[an error occurred while processing this directive]
|
#set ADDR_PINS B'00000000 ; <<< select used address lines
; A23..A16 to be output.
; This is the value to be set in HACR-register. "1" means: pin used as
; IO-port. (B'10000000 => A23 not used, B'00000001 => A16 not used)
;#set BUS_SIGNAL B'00011110 ; <<< enable bus control signals
#set BUS_SIGNAL B'00011110 ; <<< enable bus control signals
; ||||||||__ ignored
; |||||||___ bus width lower memory (0:16, 1:8Bit)
; ||||||____ output WR signal(s) (1: enabled )
; |||||_____ bus width upper memory (0:16, 1:8Bit)
; ||||______ bus width ext IO area (0:16, 1:8Bit)
; |||_______ enable HRQ input (1: enabled )
; ||________ enable RDY input (1: enabled )
; |_________ output CLK signal (1:enabled )
E-mail: info@telesys.ru