/* - lnk2313.xcl -
*
* XLINK command file for the ICCAVR C-compiler using the --cpu=2313, -mt
* options. Segments are defined for an AT90S2313 without external memory.
*
* Usage: xlink your_file(s) -f lnk2313
*
* File version: $Revision: 5794 $
*/
/*
* Modify the lines below to alter the size of the RSTACK, CSTACK and HEAP
* segments. These need to be fine tuned to suit your specific application.
* The '_..X_' prefix is used by C-SPY as an indication that the label should
* not be displayed in the dissassembly window.
*/
-D_..X_CSTACK_SIZE=20 /* 32 bytes for auto variables and register save. */
-D_..X_RSTACK_SIZE=10 /* 16 bytes for return addresses, equivalent to */
/* 8 levels of calls, including interrupts. */
-D_..X_HEAP_SIZE=10 /* 16 bytes of heap. */
-D_..X_TINY_HEAP_SIZE=10 /* 16 bytes of heap. */
/* Define CPU */
-ca90
/*
* The following segments are located in the internal memory of
* the AT90S2313. Do not change these lines.
*/
/* Code memory */
-Z(CODE)INTVEC=0-15 /* 11 Interrupt vectors * 2 bytes each */
/* Fill unused interrupt vector's with RETI */
-H1895 -h(CODE)0-15
-Z(CODE)TINY_F=16-FF
-Z(CODE)SWITCH,INITTAB,DIFUNCT=16-7FF
-Z(CODE)CODE=16-7FF
-Z(CODE)NEAR_F=16-7FF
-Z(CODE)TINY_ID,NEAR_ID=16-7FF
-Z(CODE)CHECKSUM#7FF
/* Data memory */
-Z(DATA)TINY_I,TINY_Z,TINY_N=60-DF
-Z(DATA)CSTACK+_..X_CSTACK_SIZE=60-DF
-Z(DATA)HEAP+_..X_HEAP_SIZE=60-DF
-Z(DATA)IOSTREAM_N#60-DF
-Z(DATA)TINY_HEAP+_..X_TINY_HEAP_SIZE=60-DF
-Z(DATA)RSTACK+_..X_RSTACK_SIZE=60-DF
-Z(DATA)NEAR_I,NEAR_Z=60-DF
/* Internal eeprom memory */
-Z(XDATA)EEPROM_I,EEPROM_N=0-7F
/* Select reduced "printf" support to reduce library size.
See configuration section in manual concerning printf/sprintf. */
/*Dlib*/
-e_PrintfSmall=_Printf
/*Clib*/
-e_small_write=_formatted_write
/*Dlib and Clib*/
-e_small_write_P=_formatted_write_P
/* Disable floating-point support in "scanf" to reduce library size.
See configuration section in manual concerning scanf/sscanf */
/*Dlib*/
-e_ScanfSmall=_Scanf
/*Clib*/
-e_medium_read=_formatted_read
/*Dlib and Clib*/
-e_medium_read_P=_formatted_read_P
/* Suppress one warning which is not relevant for this processor */
-w29
/* Code will now reside in file aout.a90 or aout.d90, unless -o is specified */
/* .d90 is the default if debug system is linked (option -r) */
/* .a90 is the default without debugging. Default format is -Fmotorola */