[an error occurred while processing this directive]
|
там есть переопределение векторов но говорится что эта настройка имеет смысл только когда старт с 0
; VECTAB: Defines the Interrupt Vector Address relocation
; Notes: This setting is ONLY relevant, if CODE_START is 0. Locate interrupts
; in your target application to the same address with uVision2
; Project-Options for Target-L166 Misc-Interrupt Vector Table Address
; (generates the L166 VECTAB directive).
%DEFINE (VECTAB) (08000H) ; default Address 0x8000
но как раз в этом случае все и грузится. А вот в случае помещения монитора в другое место нет. По какой то причине машина не посылает Start_Mon команду
E-mail: info@telesys.ru