Разработка, производство и продажа радиоэлектронной аппаратуры
|
Требуется программист в Зеленограде - обработка данных с датчиков; ColdFire; 40 тыс.
e-mail: jobsmp@pochta.ru
|
Под рукой оказался datasheet на am29F010A, там вот что сказано
Отправлено
11 10 февраля 2007 г. 15:33
В ответ на:
Программирование 29F800 отправлено
-Alex- 10 февраля 2007 г. 04:37
The hardware sector protection feature disables both
program and erase operations in any sector. The hardware
sector unprotection feature re-enables both
program and erase operations in previously protected
sectors.
Sector protection/unprotection must be implemented
using programming equipment. The procedure requires
a high voltage (VID) on address pin A9 and the
control pins. Details on this method are provided in a
supplement, publication number 20495. Contact an
AMD representative to obtain a copy of the appropriate
document.Т.е. если у вас секторы "залочены", то записать без программатора неполучится, нужно высокое напряжение подавать. А если секторы "не залочены", то можно. Для того чтобы узнать "залочены" ли секторы нужно, вам почитать раздел "Autoselect Mode"
The autoselect mode provides manufacturer and device
identification, and sector protection verification,
through identifier codes output on DQ7–DQ0.
To access the autoselect codes in-system, the host
system can issue the autoselect command via the
command register, as shown in the Command Definitions
table. See “Command Definitions” for details on using the autoselect
mode.
Составить ответ | Вернуться на конференцию
Ответы