[an error occurred while processing this directive]
[an error occurred while processing this directive]
|
При случае обязательно проверю на чипе этот режим(сам я его не применяю).А выполняется ли следующее замечание :
If the RSTDISBL Fuse is programmed, then the programming hardware should apply +12V to PB5 while the ATtiny12 is in
Power-On Reset. If not, the part can fail too enter programming mode caused by drive contention on PB0 and/or PB5.
Например,если программировать AVReal-ом то у него просто неоткуда взяться +12В.
E-mail: info@telesys.ru