[an error occurred while processing this directive]
|
Command:
+MEGA8 -p1 -as -%
% LPT base port 0x378
% assume that LPT data writes not faster then 1uS
% Atmel adapter for STK*00 found
% STK mode
% osc = 800kHz -> setup=3, hold=3,2
% Reset
% PgmOn reply 0xFFFE5300
% Synchronised after 1 try
% GetID reply 0x0030001E
% GetID reply 0x00300093
% GetID reply 0x00300007
% Read ID: 0x1E9307
Device connected, MEGA8 detected
% ReadLock command 0x58000000
% ReadLock reply 0x005800FF
Chip not locked
% ReadOsccal command 0x38000000
% ReadOsccal reply 0x003800B9
% ReadOsccal command 0x38000100
% ReadOsccal reply 0x003800B9
% ReadOsccal command 0x38000200
% ReadOsccal reply 0x003800B0
% ReadOsccal command 0x38000300
% ReadOsccal reply 0x003800B0
% ReadFuses command 0x50000000
% ReadFuses reply 0x00500001
% ReadFuses command 0x58000000
% ReadFuses reply 0x005800FF
% ReadFuses command 0x58080000
% ReadFuses reply 0x005808D9
Fuses
OSCCAL = B9, B9, B0, B0
BODLEVEL = 0
BODEN = 0
SUT = 0
CKSEL = 1
BLB1 = 3
BLB0 = 3
RSTDISBL = 1
WDTON = 1
CKOPT = 1
EESAVE = 1
BOOTSZ = 0
BOOTRST = 1
Reset pin released
Adapter disabled
что дальше то сделать???
E-mail: info@telesys.ru