Error connecting to the target:
Error 0x80000242/-1143
Fatal Error during: Memory, Initialization, OCS,
The memory at 0x000000BE continually indicated it was 'not ready'
All memory operations currently in progress were aborted in order
to regain control of the processor.
This is considered a catastrophic event, but the debugger should
still be able to access memory and CPU registers.
System state has been altered. It is strongly advised
that the processor should be reset before resuming execution,


Sequence ID: 0
Error Code: -1143
Error Class: 0x80000242
I/O Port = 240

Board Name: vc5510a
Cpu Name: TMS320C5500_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.

Выдается и в 3.1 и в 3.3

xdsprobe

-----[Test the emulator's JTAG controller hardware]--------------------------

Starting the Control Register Reset Test.
Finished the Control Register Reset Test.

Starting the Control Register Read-Write Test.
Finished the Control Register Read-Write Test.

Starting the Serial Buffer Normal Read-Write Test.
Finished the Serial Buffer Normal Read-Write Test.

Starting the Serial Buffer Reverse Read-Write Test.
Finished the Serial Buffer Reverse Read-Write Test.

Starting the Status0 Register Test.
Finished the Status0 Register Test.

Starting the Status1 Register Test.
Finished the Status1 Register Test.

Starting the Status2 Register Test.
Finished the Status2 Register Test.

Starting the Status3 Register Test.
Finished the Status3 Register Test.

Starting the Counter Capture Test.
Finished the Counter Capture Test.

Starting the Loop-Back with Reads and Writes Test.
Finished the Loop-Back with Reads and Writes Test.

Starting the Loop-Back Test with All-Ones Test.
Finished the Loop-Back Test with All-Ones Test.

Starting the Loop-Back Test Using All-Zeros Test.
Finished the Loop-Back Test Using All-Zeros Test.

Starting the Loop-Back with Recirculation Test.
Finished the Loop-Back with Recirculation Test.

Starting the Serial Buffer Observe Flag Test.
Finished the Serial Buffer Observe Flag Test.

Starting the State Command's State Machine Test.
Finished the State Command's State Machine Test.

Starting the Counter1 and Counter2 Test.
Finished the Counter1 and Counter2 Test.

None of the test-cases have detected errors.

C:\CCS33\cc\bin>PAUSE
Для продолжения нажмите любую клавишу . . .


Это все при внешнем эмуляторе. При попытке использовать набортный (плата 5510DSK от Спектрума) вообще говорит, что питание loss и мол досвидания).

Чего копать?