[an error occurred while processing this directive]
|
Объявил как Hardware Probe Point.
// probe point
// origin = 0x020000, length = 0xFC00
При пытке присвоить точке указанные параметры - выдает сообщение недостаточно памяти.
Размер кучи 4096.
Объявил
// origin = 0x020000, length = 0x0100
Чего-то побежал на адрес 0x00040000:
Trouble Reading Memory Block at 0x20000 on Page 1 of Length 0x100:
Error 0x80000002/-1154 Fatal Error during: Memory, The memory at
0x00040000 continually indicated it was 'not ready' The emulator
was unable to regain control of the processor. The processor must
be reset.
Sequence ID: 65 Error Code: -1154 Error Class: 0x80000002
Увеличил кучу в два раза тоже самое.
Уменьшил длину до 16 байт (0x0010) аналогично :-(
Может почитать инструкцию? ;-)
Только какую?
В документах, которые шли с CCS, не нашел.
О файловом вводе выводе я прочитал в лекциях SEN M KUO и BOB H LEE.
Информация довольно скудная:
Probe point is an important and useful feature of CCS. The probe point setting is similar to setting breakpoints. The file I/O is connected to the line where probe point is set by File-File I/O. You need to provide file name, data address and length, and connect the file to the I/O port.
P.S. Интересно на чем работает народ? Только SM и делиться советами.
E-mail: info@telesys.ru